Luno5 light switch manual
www.eledo.pl
6
sp
ots on sensors visible in fig
. 8). H
oles makes transmission of optical signals from sensors possible that enables proper people
counting
. Y
ou can use included plastic overlays
(6 pieces) to aesthetically edge around the holes. An example of the assembly of
sensors on the door frame can be found in figure 9. It is also possible to place the sensors flush with the surface of the door frame
by drilling 26-mm holes in the door frame and placing the whole sensors there.
In order to maintain aesthetics, it is recommended to put sensor wires inside the door frame. As the need arises it is possible to
pull wires through narrow holes, you can cut sensor wires and reconnect them e.g. by a terminal block. Instead of placing sensors
on or inside the door frame it is also possible to place them in front of an entrance on the side walls provided that the distance
between two sensors of a
particular pair won’t be bigger than 2 m. This way of assembly is convenient because it enables turning
lights on when the room is closed. In the case when the distance between opposite sensors is bigger than 1 m you can remove the
white sticker from the sensors to increase device sensitivity.
Fig. 8. Placement of direction sensors and wiring
– enlarged sensors.
Fig. 9. An example of installation of sensors outside and inside the door frame (one side visible).