Luno5 light switch manual
www.eledo.pl
10
8)
If we shortly push
„ ” eight times then we will enter a mode of changing the time (from 30 seconds to 3 minutes) of delay to
turn the lights off after holding (1.5 sec
.) „ ” button. Each push of the „ ” button turns the lights off after 30 seconds.
Programming this function changes this time to 3 minutes.
The 30 second time delay is useful when the Luno5 switch is mounted inside the room. It allows the user to go to bed with the
lights on. After programming the function, up to 8 lights will be off after 3 minutes instead of 30 seconds which can be useful when
the switch is mounted inside a bathroom. The washroom fan can stay on for 3 minutes after the user leaves the bathroom. If a user
goes inside during this time then the lights will stay on.
-
IMPORTANT
– when you finish setting functions you need to confirm your choice by holding the „ ” button for 6 seconds. This
action concludes programming and causes the device to remember the chosen functions. You can program a few functions at the
same time and then confirm your choice by holding the
„ ” button for 6 seconds.
- you can abort programming anytime by pushing the
„
” button. Programming procedure will be terminated automatically if you
don’t press any button for several dozen seconds.
An example of programming the change of entrance to directionally opposite:
- push and hold the
„ ” and „
” buttons
- after a few seconds release the
„
”
button and keep pushing
„ ”
button
- the button
„ ”
needs to be held on for about 20 seconds until the display illuminates (digit 0).
- after the display illuminates, you need to release the
„ ” button (display flashes quickly) and then shortly push the „ ” button
twice (display will show digit 2).
- push the
button (
auto/manual)
(and symbol
will illuminate, which means that the function is active)
- finish programming by holding the
„ ” button for 6 seconds.
Proposition of programming the function for the switch mounted inside the room
– activate functions 3, 6, 7
Proposition of programming the function for the switch mounted inside the bathroom
– activate functions 7, 8
Proposition of programming the function for the switch mounted inside the washroom
– activate functions 6, 8
Proposition of programming the function for the switch mounted inside the kitchen
– activate functions 3, 7, 8
6.
Additional options
The automatic light switch has a slot inside the controller (fig. 14) to which you can plug additional wires in. These wires can be
used to connect other additional sensors or devices.
It is possible to turn on additional switch functions like:
a) the support of hallways equipped with few separate doors.
b) the support of automatic lights on after opening any doors. The light will be on after opening doors
– before entering the
room.
c) connecting additional motion sensor that works with the Luno5 device
– it decreases the probability of possible people
miscount and turning the lights on when the room is dark and motion inside is sensed.
d) connecting an additional sensor measuring the level of light intensity in the supervised room (recommended when the
Luno5 device is located outside a supervised room) e.g. the switch in front of bathroom doors.
e) steering of an additional device that turns on music, AC or heating when users enter a room.
f)
steering of the room light through other devices mounted inside the building. (this function enables e.g. turning the lights off
or on in the whole building from one spot).
g) steering lighting that requires power larger than 100W for energy-saving bulbs or 500 W for traditional bulbs.
h) connecting an additional 5V power supply (in the case when installed, the box has no neutral conductor).
Warning ! Yo
u shouldn’t deconstruct more than the front panel of the Luno5. Some elements inside can be live! Touching these
elements can cause electrocution. Work on a live device can be conducted only by a trained specialists.