Page 17 of 24 M8165 Issue 1.1
9. MAINTENANCE.
9.1. General Information.
Unplug the unit from the mains voltage supply and allow it to cool before
undertaking any maintenance tasks.
Maintenance should only be carried out under the direction of the Responsible
Body, by a competent electrician. Failure to do so may result in damage to the product
and in extreme cases be a danger to the end user.
With proper care in operation this equipment has been designed to give many years of
reliable service. Contamination or general misuse will reduce the effective life of this
product and may cause a hazard.
Maintenance for the unit should include:
Periodic electrical safety testing (an annual test is recommended as the minimum
requirement).
Regular inspection for damage with particular attention to the mains lead and
plug set.
Routine cleaning of the equipment should be undertaken using a clean cloth.
DO NOT USE SOLVENTS FOR CLEANING ANY PART OF THIS
EQUIPMENT.
9.2. Fuse Replacement.
The mains fuse holder is located at rear your product. Refer to Technical specification,
‘Fuse Rating’ for correct fuse type and rating. Turn your product off and disconnect it from
the mains supply.
EME6-way Mantle:
Unscrew both fuse holder caps from the fuse housings and
remove the fuses. Fit replacement fuses of the correct rate and value.
EME3
–way Mantle:
Open the draw of the IEC mains electrical input socket. Remove
fuses and fit replacement fuses of the correct rate and value.
OR
EME6-way Mantle:
EME3
–way Mantle
