Page 10 of 24 M8165 Issue 1.1
USA Notification
.
Warning !
Any modification or changes made to this device, unless explicitly approved by Electrothermal
Engineering Limited, will invalidate the authorisation of this device. Operation of an unauthorised device is
prohibited under Section 302 of the Communications Act of 1934 as amended, and Subpart 1 of Part 2 of
Chapter47 of the code of Federal Regulations.
Note:
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
6. ENVIRONMENTAL PROTECTION.
6.1. Electrothermal has given due consideration to environmental issues within the design
and manufacturing process without compromising end product performance and value.
6.2.
Packaging materials have been selected such that they may be sorted for
recycling.
6.3.
At the end of your product and accessories life, it must not be discarded as
domestic waste. Ref: EU Directive 2002/96/EC on Waste Electrical and Electronic
Equipment Directive (WEEE). Please contact your distributor / supplier for further
information. For end users outside of the EU consult applicable regulations.
6.4. This product should only be dismantled for recycling by an authorised recycling
company.
This product and accessories must be accompanied by a completed
Decontamination Certificate prior to any disposal.
Copies of the Certificate are
available from your distributor of Electrothermal products, or you may copy and
enlarge from ‘Appendix A’ of the instruction book.
Electrothermal is registered as Electrothermal Engineering Limited with the Environment Agency as a producer
of WEEE (Waste Electronic and Electrical Equipment) through b2b Compliance
,
an authorised waste collection
compliance scheme.