Electronics International MVP-50P, Installation Instructions Manual

Page: 47 / 105

43
4.5 Connect the MVP Harness to the Audio Panel:
If the voice alarms provided by the MVP are to be used, route the two MVP Voice Warning Out wires to the
Audio Panel, cut the wires to length and connect to the Audio Panel Aux input and ground. If an audio input is
not available on the Audio Panel (or an Audio Panel is not installed) you can connect the MVP Voice Warning
Out wires to the pilot headset jack. With this installation a 49.9 ohm 1/4 watt resistor will need to be installed
in series with the MVP +Voice Warning Out wire and the audio feed wire to the jack.
Moving Map Data In (Grn, Pin 8)
Fuel Flow Data Out (Wht, Pin 7)
Wire Cable
GPS
MVP
GPS Input &
Output
+Voice
(Wht/Blue, Pin 23)
-Voice
(Wht/Gray, Pin 24)
Audio Feed (from Radios)
Pilot's Audio Jack
49.9 Ohms
MVP
Voice Output
Gnd
To Gnd (Blk)
To 12V (Wht)
or
To 24V (Wht)
MVP
Back Light Cntrl
Input
(Wht/Org, Pin 25)
Wht/Brn
Wht/Red
Blk
Wht/Org
4.6 Connect the MVP Harness to the External Intensity Control Pot (CP-1):
If the MVP display intensity is to be controlled externally, route the MVP Back Light Control In wire (orange)
to the CP-1, cut the wires to length, install the appropriate connectors (see the “Working with
Connectors” section of this manual for more information) and connect to the CP-1. Install the
ground and power wires to the CP-1 as shown in the paperwork supplied with the control pot.
4.7 Connect the MVP Harness to the Moving Map Data Out from the GPS:
If the MVP is to provide fuel data to the current way point, route the MVP "Moving Map Data In" wire (green
wire in a 4 wire cable) to the Moving Map Data Output Port on the GPS. Cut the wire to length, install the
appropriate connector and connect to the GPS port.