Vaping from your Endurance Ecig is very similar to smoking
traditional tobacco cigarettes. It’s as simple as pressing a fully
assembled ecig to your lips and inhaling. However, over time
you will find that there are some subtle differences. Due to the
fact that your ecig is an electronic component that uses a heating
element to vapourise the liquid, it is important to use a couple of
techniques to maximize vapour production which we will out
line below:
•
Make sure that your ecig is either pointing down or does
not pass horizontal to prevent the liquid being sucked
through the cartridge and into your mouth when taking a
drag.
•
When using your ecig for the first time or after an ex-
tended period of time of non use, you should take a few
primer puffs to pull the liquid onto the atomiser to prime
it.
•
When taking a drag suck lightly and for a longer time
than you normally would when smoking a normal ciga-
rette. (this helps the atomiser reach optimal temperature
for vapour production). If you draw too hard for too
short a period of time, the ecig will not produce optimal
results. The longer you draw on the ecig the more vapour
it will produce.
In order to keep your E-Atomiser in top working order, we en-
courage you to manually clean it as soon as you start to see a
build up on it. Also, if you have mistakenly flooded the E-
Atomiser with too much e-liquid you can use the following
guideline to clean it and get it back to top form.
To clean your E-Atomiser you will need the following items.
•
Rubbing alcohol/vinegar (solvent)
•
Water
•
Paper towel
Completely submerge the atomiser in the solvent of your choice
and let it soak for 15 minutes. After letting it soak, remove the
atomiser and either thoroughly rinse it in a cup of warm water
or run it under a tap to completely remove the solvent. Leave
the atomiser standing on end on a dry paper towel overnight to
drain and air-dry.
To assemble your ecig start by connecting the E-
Atomiser to the E-Battery. The E-Atomiser comes en-
cased in the transport cartridge (blank cartridge) that will
need to be removed. To do this, screw the E-Atomiser
and the E-Battery together ad remove the transport car-
tridge as shown:
Next replace the empty cartridge with a prefilled E-
Cartridge. Slide it over the E-Atomser and firmly press it
on to puncture the tin-foil seal. Next, twist the E-
Cartridge clockwise 3 times to create a solid connection
with the E-Atomiser. This will allow the juice to flow
down onto the E-Atomiser.
And that’s it! You are now read to vape. It’s a good idea
to remove any tin-foil remnants that may be left on the
E-Atomiser after placing a new E-Cartridge on your ecig.
To do this, simply remove the E-Cartridge and scrape the
tinfoil remnants off the bridge of the E-Atomiser then
reapply the E-Cartridge.
How to assemble your ecig
How to Vape with your ecig
How to clean your E-Atomiser
Summary of Contents for AUSSIE BLUE ENDURANCE
Page 4: ...Troubleshooting ...
