30
Tilt function (optional equipment)
10
10
11
3484
12
3485
12
11
6025
Test the tilt function:
• Switch on the machine electrical switch(es)
and turn on the compressed air supply.
• Open the door and lock it open.
• The uppermost switch on the tilt control
unit tilts the machine either backwards (turn
switch anticlockwise) or forwards (turn switch
clockwise). The middle switch returns the
machine to its normal (upright) position. The-
se switches must be kept actuated throug-
hout the entire tilt movement. If the switch is
released, the tilt movement will halt and the
machine will stop in its position.
• The bottom switch on the control unit rotates
the drum either clockwise or anticlockwise.
• Check that the machine cannot tilt in the
opposite direction until it has returned to its
normal position after an earlier tilt.
• Check for any possible leaks from compres
-
sed air lines or from bellows and sensors.
Refit the machine panels/covers.
Fit two nut clips to each corner post. The nut
clips slot into the rear grooves on the posts.
Fit the rubber dampers and sleeves to the front
end of each side panel strip.
Nut clip
Screw
Sleeve
Washer
Rubber
damper
Nut
