10 - ENGLISH
must be made without using the blade. KICKBACK can
occur when cutting is done with the risk sector of the
blade; we recommend cutting with the rest of the blade.
Take care that the cup supporting the blade just grazes
the ground. This will prevent the blade from touching the
ground.
This section contains information useful for maintaining
the characteristics of eco-compatibility included in the
origin design of the machine, and as regards proper use
and disposal of oil and fuel.
Design
In the design stage, care was taken to develop an engine
with reduced consumption and low emissions of noise
and pollutant exhaust fumes.
Use of machine
The operations of filling the tank with the fuel mixture
should be carried out in such a way as to avoid spilling
fuel and contaminating the soil and environment.
Periods of prolonged disuse
Always empty the fuel tank with the same precautions
used in filling it (
O
).
Disposal
Do not dispose inappropriately of the machine when it is
no longer usable. Deliver it to an authorized organization
for proper disposal in compliance with the regulations in
force.
The engine continues to have problems: contact your authorized supplier
N1. CAUTION!
WE RECOMMEND THE USE OF
ORIGINAL ACCESSORIES AND
REPLACEMENTS; THESE CAN BE FOUND AT
YOUR OFFICIAL DISTRIBUTOR'S. THE USE
OF ACCESSORIES AND REPLACEMENTS
THAT ARE NOT ORIGINAL INCREASES THE
DANGER OF ACCIDENTS AND IN THIS CASE
THE MANUFACTURER IS NOT LIABLE FOR
ANY DAMAGES TO PERSONS OR
PROPERTY.
O. Environmental information
P. Troubleshooting table
The engine does not
start
The engine stutters
or loses power
The machine starts
but does not cut
properly
Make sure the STOP switch is on I.
●
Make sure that the fuel tank is at least 25% full.
●
●
Make sure the air filter is clean.
●
●
Remove the sparkplug, dry and clean it, then return
it to its place. If necessary, replace it.
●
●
Change the fuel filter. Contact your supplier.
●
Follow the correct procedure for assembly of the
cutting accessories.
●
Make sure the metal accessories are sharp, and
contact your supplier if necessary.
●
