40
Aqua Control
The inlet hose is provided with a water
stop device, which protects against dam-
age caused by water leaks in the hose
which could develop due to natural age-
ing of the hose. This fault is shown by a
red sector in the window „
A
”. Should this
occur, turn the water tap off and refer to
your Service Centre to replace the hose.
Water drainage
The maximum permitted difference between the height of the surface on
which the appliance is installed and the water outlet is 1 metre.
Only original hoses may be used to extend hoses. (A maximum of 3 m laid
on the floor and then 80 cm vertically). The Customer Care Department
stocks outlet hoses of different lengths.
Draining water into a sink outlet
Secure the outlet/sink outlet joint with a
hose band clip (available from your deal-
er).
Draining water into a wash basin/bath
1
Important!
–
Small basins are not suitable. Water
may overflow.
–
The end of the drain hose must not be
in the water that has been pumped out.
Otherwise water could be sucked back
into the appliance.
