Electrolux Saladette 950, Installation And Operating Manual

Page: 19 / 26

19
Polyethylene
• Outer wrapping
• Instructions bag
Polypropylene
• Straps
Polystyrene foam
• Corner protectors
The parts in wood and cardboard can be disposed of,
respecting the current regulations in the country where the
machine is used.
F.4 Storage
The machine and/or its parts must be stored and protected
from damp, in a non-aggressive place, free of vibrations and
with room temperatures between 5
℃ and 50 ℃ .
The place where the machine is stored must have a flat
support surface to avoid deforming the machine or damage to
the support feet.
CAUTION
Do not make modifications to the parts
supplied with the appliance. Any missing
or faulty parts must be replaced with
original parts.
The appliance must be levelled, otherwise
its operation could be affected.
G INSTALLATION AND ASSEMBLY
WARNING
Refer to “ Warning and Safety
Information “
G.1 Introduction
To ensure correct operation of the appliance and maintain safe
conditions during use, carefully follow the instructions given
below in this section.
CAUTION
Before moving the appliance make sure
the load bearing capacity of the lifting
equipment used is suitable for its weight.
G.2 Customer's responsibilities
The tasks and works required of the Customer are:
• arrange an earthed power socket of suitable capacity for the
input specified on the data plate;
• provide a high sensitivity manual-reset differential thermal
magnetic switch;
• for information regarding the electrical connection, refer to
“A.12 Electrical connection “;
• check the floor planarity on which the appliance is placed.
G.3 Positioning
Install the appliance in a ventilated place, away from heat
sources such as radiators or air conditioning systems, to allow
correct cooling of the refrigerating unit components.
To avoid compromising proper appliance operation, never
(even temporarily) cover the condenser or the front panel slits.
The machine must be taken to the place of installation and
removed from the packing base only when being installed.
If the machine is installed in a place where there are corrosive
substances (chlorine, etc.), it is advisable to go over all the
stainless steel surfaces with a rag soaked in paraffin oil to
create a protective film.
Arranging the machine:
• position the machine in the required place;
• make sure the appliance is level, also checking door and
drawer closing;
The appliance must be levelled, otherwise its operation could
be affected.
G.4 Fitting anti-tipping cables
1.
2.
4,2x9,5