4
First Steps
Adjusting front rollers
ROLLER ADJUSTING
BOLT
Before starting refrigerator, follow these important first steps:
Location
• Choose a place near a grounded electrical outlet. DO NOT use an extension cord
or adapter plug.
• If possible, place refrigerator out of direct sunlight, and away from range,
dishwasher, or other heat sources.
• Refrigerator must be installed on a floor that is level and strong enough to support
a fully loaded refrigerator.
• Consider water supply availability for models equipped with an automatic ice maker.
Installation
• Do not install refrigerator where temperature will drop below 60°F (15°C) or rise
above 110°F (43°C). Compressor will not be able to maintain proper temperatures.
• In a recessed installation, allow an extra 1/2 inch (10-15 mm) on each side for ease
of installation.
• If hinge side of unit will be placed against a wall, allow a 1 3/4 inch (44 mm) space
between wall and refrigerator to permit proper door swing.
Door Opening
For best use of drawers and freezer basket, refrigerator should be in a position where
both refrigerator and freezer doors can be opened about 135°.
Leveling
• Refrigerator must be leveled with all bottom corners resting firmly on a solid floor.
Adjust front rollers to level cabinet both front-to-rear and side-to-side. Keep cabinet
as low as possible for stability.
Never adjust cabinet rollers so front is lower than
rear.
•
To adjust front rollers:
Open refrigerator and freezer doors. Remove toe grill by
pulling it straight out. Adjust rollers by turning each roller adjusting bolt with an
adjustable wrench or socket wrench until refrigerator is level and stable. Rear rollers
are not adjustable.
• Check both doors to be sure seals touch cabinet evenly on all four sides.
• If freezer door is higher than refrigerator door, raise right corner and/or lower left
corner until doors align across top of cabinet.
• If refrigerator door is higher than freezer door, raise left corner and/or lower right
corner until doors align across top of cabinet.
•
To replace toe grill:
Line up clips with holes, and push grill straight on.
Cleaning
• Wash inside, all removable parts, and outside with mild detergent and warm water.
Wipe dry.
DO NOT USE HARSH CLEANERS ON THESE SURFACES.
• Do not use razor blades or other sharp instruments that can scratch appliance surface,
when removing adhesive labels. Any glue left from tape or energy label can be
removed with a mixture of warm water and mild detergent, or—
touch residue with
sticky side of tape already removed.
• DO NOT REMOVE SERIAL PLATE.
Replacing Toe Grill
Summary of Contents for MRS20HRADD
Page 1: ...READ AND SAVE THESE INSTRUCTIONS P N 218716801 0101 ...
Page 15: ...15 Normal Operating Sounds ...
Page 18: ...18 Notes ...
Page 19: ...Notes ...
