10
SETTING SURFACE CONTROLS
Heating with inner (small)
element only
Heating with both
elements
Fig. 1
Fig. 2
Dual radiant surface elements
Ceramic glass cooktops only
(some models)
Symbols on the backguard indicate which coil of the dual
radiant element will heat. The symbol indicates the
inner coil only (See Fig. 1). The symbol indicates both
inner and outer coils will heat (See Fig. 2).
You may switch from either coil setting at any time during
cooking.
See
Suggested surface element settings
table
on previous page.
To operate a dual radiant element:
1. Place correctly sized cookware on dual radiant surface
element.
2. Push in and turn the surface control knob clockwise
to begin heating both the inner and outer portions of
the dual element. If only the inner heating portion is
needed like for smaller cookware, push in and turn the
knob counter-clockwise to start.
3. When cooking is complete, turn the dual radiant
surface element OFF before removing the cookware.
Areas that heat are shown
darkened.
Start most cooking operations on a higher setting and then
turn to a lower setting to finish cooking. The surface control
knobs do not have to be set exactly on a particular mark.
Use the marks as a guide and adjust the control knob as
needed. A glowing red surface heating area extending
beyond the bottom edge of the cookware indicates the
cookware is
too small
for the surface heating area.
Surface elements may appear to have cooled after they
have been turned off.
The surface may still be hot
and burns may occur if the surface is touched before it
has cooled.
On ceramic glass cooktops, the
hot surface
indicator
light will continue to glow AFTER the control knob
is turned to the OFF position and will glow until the
heating surface area has cooled.
CAUTION
IMPORTANT
Do not allow aluminum foil, or ANY material that
can melt to make contact with the heating elements
or ceramic glass cooktop.
If these items melt they will
damage the ceramic cooktop.
Summary of Contents for MFF3015
Page 34: ...34 NOTES ...
Page 35: ...35 NOTES ...
