Electrolux KOCDP61X, User Manual

Page: 12 / 44

7.2 Fast Heat Up
The fast heat up decreases the heat up
time.
Do not put food in the oven
when the Fast heat up
operates.
1. Turn the knob for the oven functions
to set the fast heat up.
2. Turn the knob for the temperature to
set the temperature.
The signal sounds when the oven is at
the set temperature.
3. Set an oven function.
7.3 Heat-up indicator
When the oven function operates, the
bars in the display appear one by one
when the temperature in the oven
increases, and disappear when it
decreases.
7.4 Steam Cooking
Use only water. Do not use
filtered (demineralised) or
distilled water. Do not use
other liquids. Do not put
flammable or alcoholic
liquids into the water drawer.
1. Set the function .
2. Press the cover of the water drawer
to open it.
3. Fill the water drawer with water until
the display shows Tank Full indicator.
The maximum capacity of the tank is
900 ml. It is sufficient for
approximately 55 - 60 minutes of
cooking.
4. Push the water drawer to its initial
position.
5. Set the temperature between 130 °C
and 230 °C.
Steam cooking gives good results
with this temperature range.
6. Empty the water tank after the steam
cooking is completed.
Wait for at least 60 minutes after each
use of the steam function to prevent hot
water from exiting the water outlet valve.
CAUTION!
The appliance is hot. There
is a risk of burns. Be careful
when you empty the water
drawer.
7.5 Water tank indicator
The tank is full.
When the tank is
full the signal
sounds. Press
any button to
stop the signal.
The tank is half
full.
The tank is emp‐
ty. When the
tank is empty the
signal sounds.
Refill the tank.
If you put too much water into the tank,
the safety outlet moves the excess water
to the bottom of the cavity. Remove the
water with a sponge.
7.6 Emptying the water tank
CAUTION!
Make sure that the oven is
cold before you start to
empty the water tank.
1. Prepare the draining pipe (C),
included in the package with the user
manual. Put the connector (B) onto
one of the ends of the draining pipe.
2. Put the second end of the draining
pipe (C) into a container. Put it at a
lower position than the outlet valve
(A).
www.electrolux.com 12