cable while holding the plug and inserting the
plug into the power outlet. Rewinding the cable
- Switch off the vacuum cleaner at both the
switch pedal and at the power outlet, remove
the plug from the power outlet by grasping
the plug not the cable and press the rewind
pedal to activate the rewinding of the cable
( guide the cable with your hand to ensure it
does not whip causing damage ).
7. Press the switch on/off pedal with your hand to
start the vacuum cleaner.
8. Adjust the suction by using the slide controller
on the vacuum cleaner or by opening / closing
the slide valve on the hose bent end.
GETTING THE BEST RESULTS
Hard Floors:
Use the dual purpose floor nozzle with
the pedal as shown.
Carpets:
Use the dual purpose floor nozzle with the
pedal as shown. Reduce suction power for
rugs and fabrics.
Loose rugs/curtains/light weight fabrics:
Reduce the suction power. Use the Floor nozzle
for loose rugs and the Small Combination nozzle (
Z1560, Z1570 ) and the Crevice nozzle ( two in one
with brush ) for curtains, cushions etc.
ASSEMBLING THE VACUUM CLEANER
INSTRUCTIONS FOR USE
3.
4.
BEFORE STARTING
1. Open the dust bag compartment cover.
2. Check that the dust bag is in place. and close
the dust bag compartmentcover.
3. Insert the hose until the catch clicks to engage.
Press the catch to disengage for removal.
4. ( Z1570 ) Attach the Telescopic tube to the hose
bent end and to the Floor nozzle. Adjust for
the height required by pushing the slide button
on the upper tube, to extend pull out the lower
tube section.
5. ( Z1550, Z1560 ) Join the tube set together and
attach with a twisting action to the Floor nozzle
and hose bent end.
6. Before using the vacuum cleaner extend out
a sufficient length of cable by extending the
Confined areas :
Use the Crevice nozzle ( two in one
with brush ) for crevices and radiators. Use the Small
Combination nozzle ( Z1560, Z1570 ) and the Crevice
nozzle (two in one with brush ) for removal of dust
coverage on furniture and slatted blinds
REPLACING THE DUST BAG
Replace the dust bag as soon as the indicator
becomes fully illuminated, when the cleaner is
operating at maximum power and the nozzle is
raised from the floor.
1. Remove the hose and open the dust bag cover.
2. Prior to the removal of the paper bag insert
the cardboard tab on the bag plate into the bag
opening, minimising the spilling of the bag
contents. Holding the cardboard bag plate, lift
out the dust bag from the bag holder.
3. Fit a new dust bag by inserting the cardboard
bag plate into the seating to the fullest extent
in the holder.
4. Position, and adjust the bottom corners and
the upper part of the dust bag into the dust bag
compartment and close the cover. Incorrect
fitting may cause for the dust compartment
cover not to close.
REPLACING THE TEXTILE DUST BAG
1. Remove the hose and open the dust bag
compartment cover.
2. Holding the bag plate, remove the dust bag
from the holder.
3. Slide the clip away from the bag to open
and empty.
4. Replace the plastic clip ensuring that both
sides of the bag are parallel. Replace the
bag into the holder.
5. Close the dust compartment cover by
pressing down until it clicks.
Note: The bag may be washed in luke warm water and
dried completely. It should not be washed in a
washing machine.
