Page 29
ELECTROLUX ICON 36” INDUCTION COOKTOP ERROR CODES
NOTE: If multiple changing error codes are displayed check for disconnected wires or cables.
TROUBLESHOOTING AND DIAGNOSIS
When an error code is displayed the letter “E” will be displayed in the
cook zone touch control LEDs (Fig. 8) and the error code number will
be displayed in the main touch control timer LED.
See the example at right.
The electronic components in the induction cooktop have built in error codes to assist in the accurate
diagnosis and repair of the unit in the event of failure. The chart found on pages 30 - 32 provides a list
of the error code numbers as well as the likely cause and suggested corrective action.
Error Codes
Error Possible Cause or Condition
Suggested Corrective Action
2
LF zone control defective key sensor
- Test cables and connections between left side cook
zones control and main power control.
- Replace left side cook zones touch control
3
LF zone control defective key sensor
4
LF zone control key sensor defective
6
LR zone control defective key sensor
7
LR zone control defective key sensor
8
LR zone control key sensor defective
10
Center zone control defective key sensor
- Test cables & connections between center/right rear
cook zone control and main power touch control.
- Replace center/right rear cook zone control touch
control
11
Center zone control defective key sensor
12
Center zone control key sensor defective
14
RR zone control defective key sensor
15
RR zone control defective key sensor
16
RR zone control key sensor defective
17
RF zone control key sensor defective
- Test cables & connections on main power/right front
cook zone touch control.
- Replace main power/right front cook zone touch control
18
RF zone control key sensor defective
19
RF zone control key sensor defective
21
Timer key sensor defective
22
Timer key sensor defective
23
Keep warm key sensor defective
24
Lock key sensor defective
25
Main power key sensor defective
30
70
AC input voltage too high at the 3 cook zones
induction module.
-Verify AC input voltage at the cooktop input.
-Verify AC main input cables, screws and jumpers.
-Replace the
fi
lter board in the 3 zones induction module
31
Internal generator error, sync in the 3 cook zones
induction module / left side cooking zones.
-Test cables & connections on left side generator circuit
board (dual).
-Replace the generator circuit board (LF/LR) in the 3
zones induction module
Induction Cooktop Error Codes continued on next page
