Electrolux EXS09JEIW, Installation Manual

Page: 9 / 62

CAUTION!
t Be sure to with insulating materials
pipe joints and refrigerant pipe on the
liquid-side and the gas-side. Ensure
that there is no gap between them.
Incomplete insulation may cause water
condensation.
How to take indoor unit apart to
connect the pipes:
1. Open the front panel
Slide the two stoppers on the left and
right sides inword until they click.
Fig.50
2.
Remove the front panel
Remove the string.
Allowing the front panel to fall forward
will enable you to remove it.
Fig.51
3. Remove the face plate
Remove the four screws.
Opening bottom of face plate for a
angle that is 30 degrees, then the top
of face plate will be take up.
Fig.52
Connect the drain pipe
Install the drain pipe of the indoor unit
1. The outlet has PTI screw bread,
Please use sealing materials and pipe
pipes.
CAUTION!
t
The drain pipe of indoor unit must be
heat insulated, or it will condense dew,
as well as the connections of the indoor
unit.
t
Hard PVC binder must be used for pipe
connection, and make sure there is no
leakage.
t
With the connection part to the indoor
unit, please be noted not to impose
pressure on the side of indoor unit
pipes.
t
When the declivity of the drain pipe
downwardsis over 1/100, there should
not be any winding.
t
The total length of the drain pipe when
pulled out traversely shall not exceed
20m, when the pipe is over long, a
prop stand must be installed to prevent
winding.
t
installation of the pipes.
9 ENGLISH