37
Never place cardboard, wood or
similar materials under the machine to
compensate for any unevenness in
the floor. Install the machine on a flat
hard floor. Make sure that air
circulation around the machine is not
impeded by carpets, rugs etc.
When the washer-dryer is levelled, try
to rock it from corner to corner. If it
does rock, adjust the legs again until it
is levelled and does not rock.
Connect the water inlet hose to a tap
with 3/4” BSP thread.
Use the hose supplied with the
washer-dryer. DO NOT USE OLD
HOSES.
The other end of the inlet hose which
connects to the machine can be
turned in any direction.
Simply loosen the fitting, rotate the
hose and retighten the fitting, making
sure there are no water leaks.
13.3
Water Inlet
Check that the machine does not
touch the wall or cupboard units.
The inlet hose must not be length-
ened. If it is too short and you do not
wish to move the tap, you will have to
purchase a new, longer hose specially
designed for this type of use.
This could be done by tying it to the
tap with a piece of string or attaching
it to the wall.
In a sink, drain pipe branch. This
branch must be above the trap so
that the bend is at least 60 cm
above the ground.
Directly into a drain pipe at a height
of not less than 60 cm and not more
than 90 cm.
The end of the drain hose must
always be ventilated, i.e. the inside
diameter of the drain pipe must be
larger than the outside diameter of
the drain hose.
The drain hose must not be twisted
or curled. Run it along the floor; only
the part near the drainage point
must be raised.
The end of the drain hose can be
positioned in three ways:
Hooked over the edge of a sink
using the plastic hose guide supplied
with the machine.
In this case, make sure the end
cannot come unhooked when the
machine will be emptied.
13.4
Water Drainage
For the correct functioning of the
machine, the drain hose must
remain hooked on the proper
support piece situated on the top
part of back side of the appliance.
90 cm
60 cm
