Electrolux EWW1142ADWA, User Manual

Page: 45 / 92

44 www.electrolux.com
Loosen or tighten the feet to adjust the
level. A correct adjustment of the
appliance level prevents vibration, noise
and the movement of the appliance when
in operation.
Never place cardboard, wood or similar
materials under the machine to
compensate for any unevenness in the
floor. Install the machine on a flat hard
floor. Make sure that air circulation
around the machine is not impeded by
carpets, rugs etc.
When the Washer-Dryer is levelled, try to
rock it from corner to corner. If it does
rock, adjust the legs again until it is
levelled and does not rock.
Check that the machine does not touch
the wall or cupboard units.
The end of the drain hose can be
positioned in three ways:
Hooked over the edge of a sink ,
using the plastic hose guide supplied
with the machine.
clockwise “DOWN”
counter clockwise “UP”
14.3 Water Inlet
14.4 Water Drainage
file
Check the mouth of water
tap, if it is not flat, please
make it flat with file.
Push down the slider, pull the
tap adapter out of the slider.
Loosen the 4 screws on the tap
adapter, insert the mouth of the water
tap into the tap adapter, then,
tighten the 4 screws. (If the mouth of
the water tap is too big, please get the
bushing out of the tap adapter before
installation.
After finishing the installation of the
water supply hose to the water tap,
connect the other side of the water
supply hose
with the water
inlet hole of
the machine.
Bushing
Screw
1.
2.
3.
5.
Turn in the plastic screw nut to
tighten the connection
of the water supply
hose with the
water inlet hole.
6.
Push down the slider, fasten
it into the other side of the
tap adapter, let go the slider.
4.
Plastic screw
nut
Water inlet
hole
Turn in Turn out
The inlet hose must not be lengthened.
If it is too short and you do not wish to
move the tap, you will have to purchase
a new, longer hose specially designed
for this type of use.
45
Fitting Hose Guide
bend
hose
2.
Adjust length to suit
trough.
Pull apart to
insert hose.
pull hose
1.
450 approx
.
Hose
Guide
Push the drain hose onto the spigot
and secure with a clamp, ensure a
loop is formed in the drain hose to
prevent waste from the sink entering
the appliance.
In a sink, drain pipe branch.
Directly into a drain pipe, at a height
of not less than 60 cm and not more
than 90 cm.
The end of the drain hose must always
be ventilated, i.e. the inside diameter
of the drain pipe must be larger than
the outside diameter of the drain hose.
The drain hose must not be twisted or
curled. Run it along the floor; only the
part near the drainage point must be
raised.
In this case, make sure the end cannot
come unhooked when the machine will
be emptied. This could be done by tying
it to the tap with a piece of string or
attaching it to the wall.
For the correct functioning of the
machine, the drain hose must remain
hooked on the proper support piece
situated on the top part of back side of
the appliance.
This branch must be above the trap so
that the bend is at least 60 cm above
the ground.
Max.
90 cm
Min.
60 cm
Max. 90 cm
Min. 60 cm