16 www.electrolux.com
The door stays locked with the
water in the drum. To continue
the cycle, you must press
(Start/Pause).
●
●
No spin option eliminates all the spin
phases and increase the number of
rinses.
No Spin ( )
By selecting this option the water of
the last rinse is not emptied out and
the drum turns regularly to prevent the
laundry creases.
The door is still locked to indicate that
the water must be emptied out.
Rinse Hold ( )
( ) Touchpad
Select “ ” option to turn
ON the sensors for the dirt and detergent
residue.
The “SensorWash” is switched ON
by default. If you want to turn OFF
the sensor press this touchpad
once. (Please see the table
“Program Options Compatibility”
for which programs can be used
with this option.)
The initial time displayed on
the control panel indicates the
time needed for the maximum
dirt level.
Please see details of detergent
usage at “Detergents Type and
Quantity of Detergent”
When using this option, machine will
automatically check the dirt level and
detergent residue in your laundry. It will
automatically adjust the washing time
and numbers of rinses according to the
load to make sure that your clothes are
really clean.
The SensorWash technology consist of 2
different sensors for detection:
1) The 1
st
Turbidity sensor detects the
dirt level at the start of cycle and
automatically calculates the actual
time needed to remove the level of
dirt in the wash; from low dirt levels
all the way to the maximum dirt level.
2) The 2
nd
Conductivity sensor will check
the amount of detergent residue after
the first rinse and the machine will
calculate the optimum number of
rinses (Maximum of 2 additional
rinses) needed to make sure that the
detergent residue is properly removed.
●
By selecting this option, the machine
will not drain the water of the last rinse
to avoid wrinkling the laundry. All
spinning phases are suppressed. This
washing cycle is very quiet, and can be
selected at night or other appropriate
times.
Extra Silent ( )
The door stays locked with the
water in the drum. To continue
the cycle, you must press
(Start/Pause).
17
Prewash Touchpad
Select this option if you wish your laundry
to be pre-washed before the main wash.
Use this option for heavy soil.
The indicator of this option will be on.
Select this option to add approximately
30 minutes of tumbling in vapour after
the rinse cycle.
The indicator of this option will be on.
Vapour ( ) Touchpad
Vapour may not necessarily be visible
inside the drum during a vapour cycle.
Vapour is created below the drum and
allowed to naturally rise into the
clothes.
At the end of the Vapour cycle, the
clothes will be warmer, softer and
detached from the drum
.
If Vapour option is selected, rinse
temperatures will be elevated.
During a vapour cycle, you may notice
vapour exiting from the drain hose of
the washer-Dryer, this is normal and
there is no cause for alarm.
Vapour may not be present during the
entire vapour cycle.
Vapour function is more effective with
half load.
NOTE
When you set this function, put the
detergent into the “ ” compartment.
This function increases the program
duration.
●
●
●
●
Delay Start Touchpad
This option makes it possible to delay the
start of the program by 30 min, 60 m
in o
r
90 min and then by every hour from 2 to
20 hours.
Th
e
de
lay you have select
ed i
s
indicated
on
the display.
Th
e end time will
increase in order to show you the
selected delay.
You must select this option after you have
set the program and before you press the
Start/
Pau
se button.
If you wish to add laundry in the machine
during the delay time, press Start/
Pau
se
touchpad to put the machine in pause
mode.
Add
laundry, close the door and
press Start/
Pa
use touchpad again.
You can cancel the delay time at any
momen
t,
by pressing
“
Delay Start
”
touchpad repeatedly till the display shows
delay time
“
”, t
hen pre
ss t
he
Start/
Pau
se touchpad.
Remote ( ) Touchpad
This option allows you to connect
washer-dryer to Wi-Fi network and to link
it to your smart phone.
By this functionality you can receive
notifications, control and monitor your
washer-dryer from your mobile devices
.
To connect the washer-dryer with your
smart phone you need:
When the door is open, remote
functions are disabled.
Connection setting and other
suggestions please refer to attached
leaflet of this user manual.
WI-FI specification requirements:
Wireless network at home with internet
connection enabled.
●
Smart Phone connected to wireless
network.
●
Frequency/
Protocol
Wi-Fi:
2.4 GHz / 802.11b-g-n
Wi-Fi:
5 GHz / 802.11 a-n
(for indoor use only)
Bluetooth Low Energy
5.0:
2.4 GHz / DSSS
Max Power Wi-Fi 2.4 GHz:
<20 dBm
Wi-Fi 5 GHz:
<23 dBm
Bluetooth Low Energy
5.0:
<20 dBm
Summary of Contents for EWW1142ADWA
Page 92: ...G0030937 001 A21791305 ...
