Electrolux EWF1141SEWA, User Manual

Page: 40 / 148

40 www.electrolux.com
Malfunction Alarm Code Possible cause Solution
Detergent over dose.
There is water
on the floor:
Machine unbalance. Redistribute laundry manually in
the drum and start the spin
phase again.
The cycle is
shorter than
the time
displayed. The appliance calculated
a new time according to
the laundry load.
Spinning
starts late or
machine does
not spin:
The electronic unbalance detection
device has cut in because the
laundry is not evenly distributed in
the drum. The laundry is
redistributed by reverse rotation of
the drum.
This may happen several times
before the unbalance disappears
and normal spinning can resume. If,
after 10 minutes, the laundry is still
not evenly distributed in the drum,
the machine will not spin. In this
case, redistribute the load manually
and select the spin program.
Pause the machine and
redistribute laundry manually.
Machine not installed properly. Make sure the levelling of the
appliance is correct. Refer to
“Installation”.
Transit bolts or packaging not
removed. Make sure that the packaging
and/or the transit bolts are
removed. Refer to
“Unpacking”.
The load may be too small. Add more laundry in the drum
or reduce spin speed.
Machines based on modern
technology operate very
economically using very little water
without affecting performance.
Registration Data lost or damaged. Restart machine by turn Off
and turn On again. If problem
not solved, please contact
Service Centre.
Machine
makes an
unusual
noise:
No water is
visible in the
drum:
Remote
function
does not
work:
Reduce the detergent quantity
(Adjust AutoDose page 22)
or use different detergent
(Refer page 29 “Detergents
Type And Quantity Of
Detergent”).