10.8 Interrupting a programme
and changing the options
You can change only some options
before they operate.
1. Press
.
The indicator flashes.
2. Change the options.
3. Press
again.
The programme continues.
10.9 Cancelling a running
programme
1. Turn the programme knob to position
to cancel the programme and to
deactivate the appliance.
2. Turn the programme knob again to
activate the appliance. Now, you can
set a new washing programme.
Before starting the new
programme the appliance
could drain the water. In this
case, make sure that the
detergent is still in the
detergent compartment, if
not fill the detergent again.
10.10 Opening the door
CAUTION!
If the temperature and level
of the water in the drum are
too high and the drum still
rotates, you cannot open the
door.
While a programme or the delay start
operates, the appliance door is locked
and the display shows the indicator
.
Open the appliance door when the
programme or the delay start
operates:
1. Press
to pause the appliance.
2. Wait until the door lock indicator
goes off.
3. Open the door.
4. Close the door and press again
.
The programme or delay start continues
to operate.
10.11 At the end of the
programme
• The appliance stops automatically.
• The acoustic signal operates (if it is
activated).
• In the display comes on.
• The indicator of the
goes off.
• You can open the door.
• Remove the laundry from the
appliance. Make sure that the drum is
empty.
• Close the water tap.
• Turn the programme knob to position
AutoOff to deactivate the appliance.
• Keep the door ajar, to prevent the
mildew and odours.
The washing programme is
completed, but there is water in the
drum:
• The drum turns regularly to prevent
the creases in the laundry.
• The door lock indicator
is on. The
indicator
flashes. The door stays
locked.
• You must drain the water to open the
door.
To drain the water:
1. If necessary, decrease the spin
speed. If you set , the appliance
only drains.
2. Press
. The appliance drains the
water and spins.
3. Turn the programme knob to position
AutoOff to deactivate the appliance.
The appliance drains and
spins automatically after
approximately 18 hours
(except for Wool
programme).
10.12 Stand-by
Some minutes after the end of the
washing programme, if you do not
deactivate the appliance, the energy
saving status activates.
The energy saving status decreases the
energy consumption when the appliance
is on the stand by.
• All indicators and the display go off.
ENGLISH
17
