Electrolux EWF 10591 W, User Manual

Page: 34 / 40

34 electrolux installation
Water drainage
The end of the drain hose can be posi-
tioned in three ways:
Hooked over the edge of a sink
using the plastic hose guide supplied
with the machine. In this case, make
sure the end cannot come unhooked
when the machine is emptying. This
could be done by tying it to the tap
with a piece of string or attaching it to
the wall.
In a sink drain pipe branch . This
branch must be above the trap so that
the bend is at least 60 cm above the
ground.
Directly into a drain pipe at a height
of not less than 60 cm and not more
than 90 cm. The end of the drain hose
must always be ventilated, i.e. the
inside diameter of the drain pipe must
be larger than the outside diameter of
the drain hose.
The drain hose must not be kinked.
P1118
P0022
The drain hose may be extended to a
maximum of 4 metres. An additional
drain hose and joining piece is available
from your local Service Centre.
Electrical connection
Information on the electrical connection
is given on the rating plate on the inner
edge of the appliance door.
Check that your domestic electrical
installation can take the maximum load
required, also taking into account any
other appliances in use.
Connect the machine to an earthed
socket.
The manufacturer does not accept
any responsibility for damage or
injury through failure to comply
with the above safety precaution.
The power supply cable must be
easily accessible after installing the
machine.
132961221 EN.qxd 24/03/2009 16.16 Pagina 34