Electrolux EWF 10479 W, User Manual

Page: 38 / 48

38 electrolux
4. Connect the hose to a tap with a
3/4” thread. Always use the hose
supplied with the appliance. The
inlet hose must not be lengthened. If
it is too short and you do not wish
to move the tap, you will have to
purchase a new, longer hose
specially designed for this type of
use
.
The inlet hose must not be lengthened. If
it is too short and you do not wish to
move the tap, you will have to purchase
a new, longer hose specially designed
for this type of use.
Note !
Installation should comply with
local water authority and building
regulations’ requirements.
The appliance must be connected to a
cold water supply.
A minimum water pressure of 0.05
MPa (0.5 bar) is required for safe
operation of the appliance.
If you cannot make the cold water
connection direct from the rising mains,
you may be able to operate the
appliance from your cold water storage
system.
P1088
There should be a minimum distance
of 5.02m (16.5 ft) between the
appliance’s inlet and the bottom of the
water storage tank.
Water drainage
This appliance is designed to be
permanently plumbed into your home's
drainage system using one of the
following methods.
1. Into a drainage standpipe.
Firstly form a hook in the end of the
drain hose using the «U» piece
supplied.
Place the drain hose into your
standpipe, which should have an
internal diameter of approximately
38mm thus ensuring there is an air
break between the drain hose and
standpipe.
When discharging into a standpipe
ensure that the top of the standpipe is
no more than 90 cm (35.4'') and no
less than 60 cm (23.6'') above floor
level.
38 mm (11.2”)
standpipe
diameter
HE C 0013
“ U ” pi e c e
suppli ed
P11 99
132972160 EN.qxd 30/03/2007 15.43 Pagina 38