- 20 -
Water connection
Connect the water inlet hose to a cold water tap with a
3/4" gas threaded orifice, after having inserted the
rugger sealing washer into the hose collar (fig.1). If the
water connection is made onto new pipes or onto pipes
which have not been used for a long time, it is advisable
to run off a certain amount of water before connecting
the machine.
Place the curved end of the outled hose into a drain
pipe having a height between 70 and 100 cm from floor
level (fig.2) or secure it to a sink (fig.3). Make sure that
the drain hose is firmly secured so that it will not slip out
or fall down from its position.
The water should drain freely and, consequently, the
drain hose should not be choked or placed in such a
way as to obstruct the normal water flow. If an exten-
sion hose is required, remember that it might cause a
malfunction in the drain pump, particularly if the exten-
sion has a length in excess of 1 meter or if the diameter
of the extension is smaller than the diameter of the
original drain hose.
Electrical connection
Before you fit the plug into the wall socket, check the
following points :
1) The supply voltage of the domestic wiring system
does not fluctuate by more that 10%, plus or minus,
from 230 V.
2) The meter, the fuses, the supply line and the wall
socket are suitable to carry the maximum load required
by the machine (2,3 kW).
Very important :
The washing machine is provided with a feeding
wire with earth connection: it must be connected
to a plug like that is provided with a good earth
connection. The wall plug must be easily accessi-
ble.
The replacing of the power cord must only be
realized by the After Sales Service in order to avoid
any danger.
The manufacturer declines any responsibility where
the previous recommendations are not followed.
Fig.2
Fig.3
Fig.1
