Handling the appliance
Putting it into use
Place the accessories into the appliance then plug to
the mains socket. The thermostat knob is installed in
the work plate on the refrigerator. You can switch the
appliance on and set the temperature with it by
turning the knob clockwise.
The next paragraph will give instructions for setting.
Controlling the temperature, setting
The thermostat interrupts the operation of the
appliance automatically for more or less time
depending on the setting then restarts it assuring the
required temperature. The closer it is set to maximum
position the more intensive the refrigerating will be.
When the thermostat knob is set to a medium
position (between minimum and maximum), in the
freezer a temperature colder than -18 00, in the
refrigerator 5 ºC can be reached. Setting it to
a medium position is adequate for everyday use.
The temperature coming about in the refrigerator is
effected by not only the position of the thermostat but
the ambient temperature, frequency of door openings
and the quantity of food put into it newly, etc.
In the maximum position - in case of
increased demand e.g. during heat waves
- the compressor may operate continually.
This does not cause damages to the
appliance.
How to use the refrigerator
For adequate cooling developing interior air
circulation is necessary. For this reason you are asked
not to cover the air circulation gaps behind the
shelves (e.g. with tray etc.).
Do not put hot food into the refrigerator.
Allow it to reach room temperature naturally. In
this way the unnecessary frost building up can be
avoided.
Foods can take over odors from each other.
So it is essential to put foods in closed dishes or wrap
them in cellophane, aluminum foil, and greaseproof
paper or cling film before placing them into the
refrigerator. This way foods will keep their moisture
e.g. vegetables will not dry out after some days.
Storing in the refrigerator
When placing the different kinds of food take into
consideration the sketch below in figure:
1.Butter, cheese
2.Eggs
3.Tubes, cans, sour cream, small bottles
4.Drinks in big bottles, soda-water and mousse
siphon
5. Frizzed food storage
6. Fast freeze
7. Fruits, vegetables, salads
8. Milk, dairy products, ready-cooked foods,
confectionery, foods in dishes covered,
opened, cans, bottles laid, fresh meat,
sausages, etc.
Storage time and temperature of foods
The storage time chart at the end of the instruction
book gives information about storage time.
The storage time can not be determined exactly in
advance, as it depends on the freshness and handling
of the cooled food. That is why the storage time made
known is only informative.
If you do not want to use up deep-frozen foods
bought immediately they can be stored for about 1
day (until dissolving) in the refrigerator.
How to use the freezer
Freezing
In the compartment various fresh food can be frozen
at home. Mind the following to get thorough result.
Freeze fresh and faultless food only. Before starting
freezing set the thermostatic control knob to
maximum position and put the wire drawer in the
frozen food compartment to the highest position.
Then put in the quantity to be frozen, directly into the
wire shelf. Freezing is completed in approx. 24
hours. After 24 hours set the thermostatic control
knob back to Medium position, which is usually
adequate for everyday use. It is practical to store the
frozen food in the lower basket.
1
6
7
8
2
3
4
5
i
i
i
i
4
Fix the double door
holder onto the left side
using the screws (2
pieces). Be careful that
the door edge of the
freezer is parallel with
the edge of the mantle
(figure 10).
Change the position of
the lower door mask
c o v e r ( F i g u r e 7 ) .
Remove opening mask
on from the work plate
and fix it to the other
s i d e w i t h d o u b l e
adhesive tape enclosed
in the bag of spare parts
(Figure 8).
Install work plate back
to the refrigerator.
Fit the door of the
r e f r i g e r a t o r t o t h e
double door hinge.
Fix the upper door shaft
onto the left side using
the screws you removed
previously. Be careful
that the door edge of the
refrigerator is parallel
with the edge of the
mantle.
Put over the handle on
the opposite side and
cover up the vacant
holes with the plastic
nails from the bag of
spare parts.
A f t e r r e l e a s e d t h e
screws the adaptation of
the doors can be
adjusted with the horizontal control of middle
door hinge.
Put the appliance to its place, set it's level with
leveling front legs, and connect it to the
electricity supply.
In case you do not want to perform the procedures
above, call the nearest brand-mark service.
Technicians will accomplish the refilling expertly
for charge.
Electrical connection
This refrigerator is designed to operate on 230
V AC (~) 50 Hz supply.
The plug must be put into a socket with
protective contact. If there is no such, it is
recommended to get an electrician to fit an
earthed socket in compliance with standards
near the refrigerator.
This appliance complies with the
following E.E.C. Directives:
- 73/23 EEC of 19.02.73 (Low Voltage
Directive) and subsequent modifications,
- 89/336 EEC of 03.05.89 (Electromagnetic
Compatibility Directive) and subsequent
modifications.
11
