23
• Remove the door by pulling it outward, making sure it does
not get stuck.
• Gently lower the door.
• Remove the tank filters “C“ - “D“ - “E“.
• Clean the filters under a water spray using a nylon brush.
Refit the door
• Lift the door as far as movement permits (horizontal).
•
Push the door inward, making sure it does not get stuck,
until the latches “S“ and “T“ are both lowered in the initial
position (all down). This operation is correctly done when
the door cannot be pulled outward on the side of latch “S“
and that of latch “T“.
• Close the door, gently lifting it.
• Select the drain cycle by pressing button “Drain/Self
cleaning“.
• The message “CLE“ will be displayed throughout the drain
cycle:
• After a few minutes, 3 beeps indicate the end of the
cleaning cycle and “END“ blinks on the display:
• Switch off the dishwasher by pressing On/Off button.
• Switch off at the mains.
• Close the water supply tap.
• Replace the filters.
K.2.2
Clean the nozzle jets
• Remove the top and bottom wash arms“F“ and rinse arms
“I“, unscrewing the ring nut “H“.
• Unscrew plugs “L“ from the rinse jets.
IMPORTANT
Descale the rinse jets “I“ every month using
vinegar or a descaling agent.
• Remove jet “P“ by turning it clockwise and pulling it out.
• Unscrew plugs “R“ from the side jets.
C
D
E
H
F
I
L
P
R
R