Electrolux EP3003011, User Manual

Page: 28 / 32

Problem Possible cause Solution
The oven does not heat up The appliance is switched off Switch on the appliance
The oven does not heat up The clock is not set Set the clock. Refer to "Setting
the clock"
The oven does not heat up The necessary settings are not
set
Make sure, the settings are cor -
rect
The oven does not heat up The automatic cut-out is
switched on
Refer to „Automatic cut-out“
The oven does not heat up The fuse is released Make sure, if the fuse is the
cause for the malfunction. If
the fuse releases again and
again, refer to an authorized
electrician
The oven lamp does not operate The oven lamp is defective Replace the oven lamp.
The pyrolytic cleaning does
not operate (the clock display
shows „C1“)
The shelf support/telescopic
runners are not removed
Remove support/telescopic
runners
The pyrolytic cleaning does
not operate (the time display
shows „C3“)
The door is not correctly
closed or door lock is defective
Close the door correctly
The display shows F2 • The door is not closed cor -
rectly
• The door lock is defect
• Close the door correctly
• Switch off the appliance
with the house fuse or the
safety switch in the fuse
box and switch it on again
• If the display shows F2
again, refer to the Custom -
er Care Department
The display shows an error
code that is not in this list
There is an electronic fault • Switch off the appliance
with the house fuse or the
safety switch in the fuse
box and switch it on again
• If the display shows the er -
ror code again, refer to the
Customer Care Department
If you cannot find a solution to the problem yourself, contact your dealer or the service
centre.
The necessary data for the service centre is on the rating plate. The rating plate is on the
front frame of the oven cavity.
We recommend that you write the data here:
Model (MOD.)
.........................................
Product number (PNC) .........................................
Serial number (S.N.) .........................................
28 What to do if…