73
GB
The most typical case of clogging up in the melting water
outlet when you put food wrapped in some paper into the
appliance and this paper contacts back plate of the
refrigerator and freezes to it. If you remove the food right at
this moment the paper will tear and it can cause clogging
up in the outlet by getting into it.
So you are asked to be careful - because of the above -
when placing foods wrapped in paper into the appliance.
In case of increased demand e. g. during
heatwawes, the refrigerator temporarily happens to
operate constantly - during this the automatic defrosting
does not work.
Remaining small ice and frost stains on back plate of the
refrigerator after defrosting period is not abnormal.
Defrosting of the freezer is automatic in this model.
Regular cleaning
Clean the equipment regularly.
Don't use detergents, abrasive or strongly
odorous cleaners, waxy polishing agents
or disinfectants or alkoholic products for cleaning
the equipment.
Before cleaning pull out the wall plug of the equipment
from the outlet.
Internal cleaning
Clean the internal parts of the equipment and the
accessories with warm water and sodium bicarbonate
(5 ml to 0.5 litre of water).
Rinse and dry everything thoroughly. Clean the door
seal profile with clean water.
External cleaning
Clean the external parts of the equipment with warm
water and sodium bicarbonate (5 ml to 0.5 litre of
water).
It is recommended to remove the dust and dirt
deposited on the back side of the equipment and on
the condenser once or twice a year, and to clean the
evaporation tray on top of the compressor.
After cleaning, reconnect the equipment to the mains
supply.
When the refrigerator
is not in use
In case the appliance will not be used for a long time
follow these steps:
Break the circuit of the appliance.
Remove foods from the refrigerator.
Defrost and clean it as written before.
Leave the door open to avoid a build up of air inside.
How to change the bulb
Should the light fail to work you can change it as below:
Break the circuit of the appliance.
Press the rear hook (1) and at the same time slide the
cover in the direction indicated by the arrow (2). So the
bulb can be replaced. (Bulb type: T 25 230-240 V, 25
W, E 14 thread)
After changing the bulb replace the cover, snap it in
place and apply voltage to the appliance.
Trouble shooting
