EN Publication
number
599 71 19-22
Rev. 01
02/2009
PR - 39/42
6.3.1 Functional description
The Aeropro PCB is supplied with main voltage, dimensioned to be used with both 230V and 100V
main power. A capacitive power supply is used to supply the electronics with 5VDC. The motor speed and
motor status in the nozzle are controlled by a triac. The triac are controlled by the cleaners control unit.
6.4 Description Remote control signal and handling
The remote control is connected to connector on the Aeropro PCB. The remote control uses a two
wire connection to the Aeropro PCB, and is connected as following:
- KEY +5V analog signal.
- M2 GND. Note: live voltage potential.
The controller on the Aeropro PCB reads the analog signal level, and converts the signal to a frequency
output signal, which is communicated to the Elara control PCB.
6.5 Motor output
The on/off of the motor nozzle is controlled by a Triac.
The motor is also connected as follows
- M1 motor phase
- M2 motor neutral (shared with the GND for the remote control)
Nozzle motor status is following:
Plug
in:
OFF
Switch cleaner on:
OFF or last status.
Switch
cleaner
off:
OFF
Auto
on: No
change
Auto off (manual):
No change
Manual power toggle: No change
Nozzle on/off:
If nozzle motor is off and cleaner motor running – turn it on
Nozzle on/off:
If nozzle motor is on and cleaner motor running – turn it off
Cleaner motor is off:
Always off.
7 INDICATION & DIAGNOSTICS
7.1 Filter and S-bag indicators
7.1.1 Activation
The indicators are operated by the controller. If the pressure switches activates, this is indicated by
the indicator LED:s.
After 2 seconds activation the corresponding LED will light up for 1 second, and after additional 57
seconds the corresponding LED will start to indicate
continuously.
During this time delay the pressure switch must not be deactivated. If it is deactivated, there will be a
new 60 second delay when activated next time.
The LED:s will continue to indicate after the cleaner is turned off and in standby mode.
At first start, after the main plug is connected, the S-BAG and FILTER indicator will turn on for one
second,
indicating that the LED:s is working.
