Electrolux EI27MO45GSA, Technical & Service Manual

Page: 42 / 52

Component Teardown
4-10
Re-Install
1. Re-install door screen to door frame.
2. Re-install the latch spring to the latch head. Re-install
the latch spring to the door frame. Re-install latch
head to door frame.
3. Re-install door panel to door frame by fitting twelve
(12) tabs of door frame to twelve (12) holes of door
panel.
4. Put sealer film on door panel. Refer to “Sealer Film”
about how to handle new sealer film.
5. Catch two (2) pins of door panel on two (2) holes of
upper door frame.
6. Re-install choke cover to door panel by pushing.
After any service to the door:
(A) Make sure that door sensing switch, primary switch
and secondary switch are operating properly. (Refer
to Section 3 “Test Procedures”.).
(B) An approved microwave survey meter should be
used to assure compliance with proper microwave
radiation emission limitation standards.
After any service, make sure of the following:
1. Door latch heads smoothly catch latch hook through
latch holes and that latch head goes through center
of latch hole.
2. Deviation of door alignment from horizontal line of
cavity face plate is to be less than 1.0mm.
3. Door is positioned with its face pressed toward cavity
face
plate.
4. Check for microwave leakage around door with an
approved microwave survey meter. (Refer to
Microwave Measurement Procedure.)
Pin
Pin
Upper
Oven Hinge
Upper Oven
Hinge
Lower Oven
Hinge
Lower
Oven Hinge
Choke Cover
Figure 4-8. Door Replacement and Adjustment
Adhesive
Tape
Backing Film
Sealer Film
Figure 4-9. Sealer Film
The door on a microwave oven is designed to act
as an electronic seal preventing the leakage of
microwave energy from the oven cavity during the
cook cycle. This function does not require that the
door be airtight, moisture (condensation)-tight
or light-tight. Therefore, occasional appearance
of moisture, light or sensing of gentle warm air
movement around the oven door is not abnormal
and do not of themselves indicate a leakage of
microwave energy from the oven cavity. If such
were the case, the oven could not be equipped
with a vent, the very purpose of which is to exhaust
the vapor-laden air from the oven cavity.
Sealer Film
1. Put the adhesive tape on the backing film of the
sealer film as shown in Fig. 4-9.
2. Tear the backing film by pulling the adhesive tape.
3. Put the pasted side of the sealer film on the door
panel.
Turntable Motor Removal
1. Disconnect the power supply cord.
2. Remove the turntable tray, and the turntable support
out of the oven cavity.
3. Lay oven on its backside. Remove turntable motor
cover by snipping off the material in four corners.
4. Where the corners have been snipped off bend
corner areas flat. No sharp edges must be evident
after removal of the turntable motor cover.
5. Disconnect wire leads from turntable motor.
(See “Positive Lock Connector Removal”)
6. Remove one (1) screw holding turntable motor to
oven cavity.
7. Now the turntable motor is free.
8. After replacement use the one (1) screw to fit the
turntable motor cover.