Electrolux EHL2BR, User Manual

Page: 18 / 24

CLEANING THE DOOR
To clean the appliance door, remove it.
Caution! Be careful when you remove
the door from the appliance. The door
is heavy. There is a risk of injury or
damage to the appliance.
Removing the door
1. Open the door as far as it goes.
2. Fully press the clamping levers (A) on
the two door hinges.
A
A
3. Close the door until the first position
(angle approximately 45°).
45°
4. Hold the door with one hand on each
side and pull it away from the appliance
at an upwards angle.
Put the door with the outer side down
on a soft and level surface to prevent
scratches.
Installing the door
To install the door follow the procedure in
reverse.
OVEN CEILING
You can fold down the heating element on
the oven ceiling to clean the oven ceiling
easily.
Warning! Before you fold down the
heating element deactivate the
appliance. Make sure that the
appliance is cold. There is a risk of
burns!
Folding down the heating element
1.
Remove the shelf supports.
2. Hold the heating element with the two
hands at the front
3. Pull it forwards against the spring pres-
sure and out along the support on both
sides.
4. The heating element folds down.
The oven ceiling is ready to clean.
Installing the heating element
1. Install the heating element in opposite
sequence.
Important! Install the heating element
correctly on the two sides above the
support on the inner wall of the appliance.
2. Install the shelf supports.
WHAT TO DO IF…
Warning! Refer to "Safety information"
chapter.
Problem Possible cause Remedy
The cooking zones do not op-
erate Consult the operating instructions for the built-in cooking surface
18 electrolux