40
20b
20b
7-16
7-16
4
5
6
12
13
8
9
14
14
15
18
20a
20a
98
19
8
9
1
17
B
G
H
11
11
10
1
1
1
3
3
3
3
21
F
1
2
2
Installation
Wall unit mounting - Fig. 9
Disconnect the hood during electrical connection, by turning the home mains switch off.
Rest the suction unit on a flat surface and thread the lower part of the hood onto it
(1)
.
Make all the electrical connections between the two parts
(2)
.
Fasten the hood to the suction unit using 10 screws
(3),
before fixing check that the metal band (steam shield)
that holds the lamp and the filter/s / greases is well attached to the front. If necessary adjust the position
of the band forwards until the end stop. .
Sign the wall with a center line, this will aid mounting procedure
(4)
, position the template so that the mid line
printed on the template matches with the center line previously signed, the lower side of the template
corresponds to the lower side of the hood once mounted
(5)
.
Drill two holes Ø 8mm and fix the support bracket with two wall plugs and screws
(6)
.
Hang the hood
(7)
adjust its position
(8-9)
and from the inside of the hood sign one
point for definitive fixing
(10)
,
remove the hood
(11)
and drill
an hole Ø 8mm
(12)
, fit a
wall plugs
(13)
.
Drill two holes Ø 8mm on
the upper side close to
the ceilling
(14)
, fit two
wall plugs and fix the
chimney support with two
screws
(15)
.
Hang the hood again
(16)
.
Fix it definitively with a
screw
(17)
. To simplify
the mounting operation
remove the carbon filter frame.
In case the hood is to be used in
filter version
, mount the
deflector
F
on the chimney
support
G
with four screws
2,9x6,5 and fit an exhausting
pipe
(18)
to connect deflector to
the outlet hole
D
of the hood.
In case the hood is to be used in
exhausting version, then the
deflector must not be mounted
and fit an exhausting pipe
(18)
to connect outlet
hole
D
of the hood to the
outside.
Make electrical
connection
(13)
, but
leave the hood
disconnected from the
home general electric
panel.
Fix the chimney
(16a)
to the
chimney support
(16b)
.
Slide down the lower section on the proper housing on
top of the hood. Connect the hood the the home general electric panel and check if the hood work properly.
Fig. 9
Summary of Contents for EFC 6420
Page 15: ...LI11TC Ed 07 04 ...