6
www.electrolux.com
CNT
EN
CLEANING AND CARE
10. Before cleaning, always unplug the appliance. Never rinse or immerse the kettle or base unit in water.
Just wipe with a damp cloth, using no abrasive detergents. Occasionally rinse out the kettle with clean
water.
11. To clean the mesh filter, slide the mesh filter (B) and lift it out. Rinse under clean, running water, and
insert it back into the kettle in the correct orientation.
Cleaning the heating plate – superficial spots of rust may appear on the base unit. Remove with a
stainless steel cleaning agent.
12.
Decalcifying is recommended regularly, depending on water hardness. Fill the kettle with water and
decalcifier according to decalcifier product instructions. Do not boil the solution as it may foam over.
Afterwards, rinse kettle thorougly with fresh water.
RECOMMENDED TEMPERATURE CHART
Temperature settings
Food and beverage
40-60 °C
Baby mixtures
80 °C
Delicate teas (green/white)
90 °C
Instant coffee or soup
100 °C
Black tea
Caution!
This appliance has a temperature selection function. In case the selected temperature is
below 100
o
C, ensure the water is first boiled before selecting the preferred temperature.
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
SOLUTION
The appliance switches off before
boiling.
Too much lime scale at the base of
the kettle.
Run the decalcifying
procedure.
The appliance does not switch off.
The lid is not closed.
Insert the mesh filter
properly. Close lid until it
locks.
The appliance cannot be
switched on.
After operating with little or no
water, the appliance has not cooled
down sufficiently.
Allow to cool a short time
and try again.
Water leakage at the bottom of
the appliance.
Residual water from previous use.
Dry the appliance before
using it.
Water over flow the “max” level
indication.
Do not fill the water above
the “max” level indicator.
Kettle was tilted towards handle.
Do not tilt the appliance
backward.
Error message E1, E2, E3 or ERR is
shown on the display.
Allow to cool a short
time and try again. If the
problem persists, please
contact Electrolux Service
Centre.
