6.7.1 Input philosophy: alter program
l
Alter program during the prestart phase
1.
Program has been selected but did not yet start
Ä
Display LD0 with ON/OFF key, program LED and run time LED are lit.
Ä
Run time to be expected is flashing in the display.
2.
By pressing the new desired program key shortly it is possible to alter directly.
Options already selected before are cleared and have to be selected anew.
Ä
Display LD0 with ON/OFF key, new program LED and run time LED are lit.
Ä
Run time to be expected is flashing in the display.
3.
Alterations can still be made within 3 seconds after actuating any key last.
If during these 3 seconds no more keys are actuated, the program will start.
Program starts running only when the door has been closed.
Special feature when also a start time was selected before!
1.
Program and start time have been selected but did not yet start.
Ä
Display LD0 with ON/OFF key, program LED and "SZV" LED are lit.
Ä
Programmed start time is flashing in the display.
2.
By pressing the new desired program key shortly it is possible to alter directly.
The start-time preselection already selected is preserverd after the alteration!
Program options already selected before, however, are deleted and must be
selected anew.
Ä
Display LD0 with ON/OFF key, new program LED and "SZV" LED are lit.
Ä
Run time to be expected is flashing in the display for 2 sec., afterwards the
start time is flashing again.
If the selected start time is already running down (the time is permanently lit in the
display) you have to press the new desired program key a longer time for
alteration (about 6 seconds).
Tastenanordnung
waagrecht
S1
S2
S3
1
99
S0
LD0
S4
S5
S6
S0
S1
1
99
S2 S3 S4 S5 S6
Tastenanordnung
senkrecht
1.
2.
LD2
S0
LD0
129
Laufzeit
LD2
S0
LD0
93
Laufzeit
Taste kurz betätigen
LD6
LD6
S2
S2
S6
Display blinkt
Display blinkt
3.
LD2
S0
LD0
112
Laufzeit
Taste kurz betätigen
LD6
S2
Display blinkt
LD1
LD1
LD1
S1
S1
26
All manuals and user guides at all-guides.com
all-guides.com
