7.3 Service function / manufacturing test routine:
General information
Calling above-mentioned service function
w
Calling the service functions is executed in all designs
Calling the function "manufacturing test routine"
resp. key arrangements analogously.
w
For that you always have to use keys S0, S1, S2 and S3
1.
Press keys S1 and S3 simultaneously and ...
independent of their variant-depending program load.
w
In the service function mode the key S3 is ALWAYS
2.
... and switch on the appliance by ON/OFF switch S0.
responsible for calling the "manufacturing test routine".
For that keep the keys S1 and S3 pressed simutaneously
until the 3 confirmation LEDs LD1, LD2 and LD3 are flashing.
3.
By actuating the function key S3 you can call the
manufacturing test routine.
The key LED LD3 continues flashing, the LEDs LD1 and LD2
go out.
4.
The test routine starts automatically.
The run time LED flashes up.
The display indicates the expected run time.
From that moment the same input philosophy is valid for the
manufacturing test routine as for normal washing cycles.
F
cycle run and cyle end
(see description page B 5 )
F
delete cycle in advance
(see description page B 6 )
F
interrupt program
(see description page B 8 )
It is generally valid:
For calling all service functions you always have first
to actuate the function keys S1 and S3 before switching
on the appliance by ON/OFF switch S0!
The keys have to remain pressed about 4 seconds to
activate the function.
This procedure is intentionally different to that for the
customer functions.
Tastenanordnung
waagrecht
S1
S2
S3
LD1
LD2
LD3
1
99
S1
LD0
S0
LD0
LD1 LD2
S1 S2
1
99
LD3
S3
Tastenanordnung
senkrecht
1.
S0
LD0
LD2
LD1
LD3
S1
S3
S0
LD0
3.
LD3
S3
blinkt
S0
LD0
2.
LD2
LD1
LD3
S1
S3
blinken
Tasten S1/S3
für ca. 4 Sek. halten
bis LD1-LD3 blinken!
S0
LD0
4.
LD3
S3
blinkt
21
Laufzeit
Fertigungsprüfprogramm
läuft ab
36
All manuals and user guides at all-guides.com
all-guides.com
