21
Changing bulb for inside light
Only use a special bulb which is designed specially for dryers. The special
bulb is available from the after-sales service,
ET-Nr. 112 552 000-5.
1
Warning!
Do not use standard bulbs! These develop too much heat and
may damage the machine!
1
Warning!
Before replacing the bulb, disconnect the mains plug; with a per-
manent connection: fully unscrew or deactivate the fuse.
1.
Unscrew covering bonnet from above bulb (this can be found directly be-
hind the loading aperture, at the top; refer to “Description of machine”
section.)
2.
Replace defective bulb.
3.
Screw covering bonnet back down.
1
Warning!
For reasons associated with safety, the covering bonnet must be
screwed down tightly. If this is not done, the dryer must not be operated.
Drying cycle ends shortly
after programme starts.
END (ENDE) display illu-
minated.
Not enough washing loaded or
washing loaded is too dry for
selected programme.
Select time programme or higher
drying level (e.g. INTENSIVE DRY
[STARKTROCKEN] instead of
STORAGE DRY [SCHRANK-
TROCKEN]).
Drying cycle lasts an un-
usually long time.
Note:
After around 5 hours the
drying cycle ends auto-
matically (see „Drying
cycle complete“).
Lint filter clogged.
Clean lint filter.
Heat exchanger clogged with
lint.
Clean heat exchanger.
SPECIAL CARE (SCHON) but-
ton pressed and load volume
too big.
SPECIAL CARE (SCHON) is only
suitable for use with loads of up
to 3kg!
Load volume too big.
Reduce load volume.
Laundry insufficiently pre-
drained.
Laundry must be adequately pre-
drained.
Problem
Possible cause
Remedy
