Electrolux EBGL3XDCN, User Manual

Page: 28 / 36

11. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
11.1 What to do if...
Problem Possible cause Remedy
You cannot activate or op-
erate the oven. The display
shows “400” and an acous-
tic signal sounds.
The oven is incorrectly con-
nected to an electrical sup-
ply.
Check if the oven is correct-
ly connected to the electri-
cal supply (refer to the con-
nection diagram if available).
The oven does not heat up. The oven is deactivated. Activate the oven.
The oven does not heat up. The clock is not set. Set the clock.
The oven does not heat up. The necessary settings are
not set.
Make sure that the settings
are correct.
The oven does not heat up. The fuse is blown. Make sure that the fuse is
the cause of the malfunc-
tion. If the fuse is blown
again and again, contact a
qualified electrician.
The lamp does not operate. The lamp is defective. Replace the lamp.
Steam and condensation
settle on the food and in the
cavity of the oven.
You left the dish in the oven
for too long.
Do not leave the dishes in
the oven for longer than 15
- 20 minutes after the cook-
ing process ends.
The display shows "12.00". There was a power cut. Reset the clock.
There is no good cooking
performance using the Ba-
kingPlus function.
You did not activate the Ba-
kingPlus function.
Refer to "Activating the Ba-
kingPlus function".
There is no good cooking
performance using the Ba-
kingPlus function.
You did not fill the cavity
embossment with water.
Refer to "Activating the Ba-
kingPlus function".
The water in the cavity em-
bossment does not boil.
The temperature is too low. Set the temperature at least
to 110 °C.
Refer to “Hints and tips”
chapter.
The water comes out of the
cavity embossment.
There is too much water in
the cavity embossment.
Deactivate the oven and
make sure that the appli-
ance is cold. Wipe the wa-
ter with a cloth or sponge.
Add the correct amount of
water to the cavity emboss-
ment. Refer to the specific
procedure.
www.electrolux.com 28