SOI/TD
2004-11
PR
/26 599
36
44-44
26
16 QUICK GUIDE TO THE SPECIAL FUNCTIONS
The table below briefly describes how each of the special functions available to the user and to the Service Engineer can be used. To activate the user mode, the
selector must be turned clockwise; to activate the Service mode, the selector must be turned anti-clockwise.
Function
Activation of the function
Starting the function
Short description / Notes
Button
Selector position
Selector
and/or
Buttons
LED(s)
Level …... .. ..... ..... ..… ... L1 … … … ... L2 … … … … … ... L10
No of flashes End of cycle LED …
1
… … … …
2
… … … … … …
10
ex. level 3: 3 flashes, pause .… repeatable] x 1min.
USER (*)
Select
Regeneration
Pos. 1
clockwise
LD0+LD1 flashing
(release S1)
S1
LD5
flashing
The End of cycle LED flashes.
The last 3 alarms are displayed pressing button
S1
repeatedly.
Display of alarms
and components
diagnostic
S1
LD5
flashing
From the fourth to the tenth actuation the single components are activated.
Cancel alarms
stored in
memory
Pos. 4
and press
S1
All LEDs
flashing
All LEDs flash for 30 seconds.
SERVICE
Test cycle
S1
(Start)
and hold down
Pos. 5
anti-clockwise
LD0+LD1 flashing
(release S1)
Pos. 3
and press
S1
LD5
flashing
The cycle starts automatically signalling the various phases in progress with
the lighting of the relative LEDs.
Exit / Memorize
In order to memorize the functions or exit diagnostics mode, switch the appliance off turning the knob to On/Off position. In most cases the memorization or the
exit is automatic after 60 seconds (in this case the appliance goes to pre-selection mode).
(*) To activate the “user” functions no cycle has to be selected: to cancel them see 5.2.1; the appliance must be in pre-selection mode.
