Page 39
Replacing Lower oven thermal Cutout
The lower oven thermal cutout is located behind the
access cover plate located at the lower portion of the
chassis near the center of the range when viewed
from behind. (Photo A)
Cover Plate
Mounting Screws
Photo A
Take out the four cover plate mounting screws and
remove the cover.
Once the cover plate is removed the lower oven
thermal cutout and harness connections are
accessible. (Photo B)
To remove the cutout, unplug the harness
connections and remove the two mounting screws.
Photo B
Thermal Cutout
Mounting Screws
Replacing Drawer Glide Rails
Once the mounting screw is removed extend the outer track of the glide rail until it stops. Pull forward
firmly until the hooks on the back of the rail disengage from the slots in the oven cavity side wall.
( Fig. 3 & 4 )
The lower oven drawer glide rails (Fig. 1) clip into
the side wall of the lower oven cavity and are se-
cured by one screw in each rail.
The mounting screw is accessed through a hole in
the glide rail outer track. (Fig. 2) .
Remove
Screw
Fig. 1
Fig. 2
Pull Forward
Glide Rail Hooks
Slots
Fig. 4
Fig. 3
