HOW TO ASSEMBLE AND USE
(continued)
3. Rest the base of the Enviro Steamer on its floorcloth
as supplied, making sure that the edges are secured
over the base. Then tuck both ends of the floorcloth
under the cloth clips (Fig. 3). Do not use without a
floorcloth in place.
4.
Unscrew the cap (D), insert funnel (J) and pour 2 mea-
sures of water using the measuring jug (I) (total 12
oz.) into the tank, then screw the cap back on.
NOTE: Do not overfill.
5.
Now, plug the unit into an electrical outlet.
Fig. 3
Fig. 4
6.
Place the Enviro Steamer on its preheating/cool
down stand then press on/off switch and wait for
about 3-4 minutes (Fig. 5). Do not leave the device
unattended during the waiting period. CAUTION: Do
not leave the device standing on the floor. If you
notice the formation of a whitish “halo,” it may be
removed using a normal decalcifying product or
with a few drops of vinegar.
7.
As soon as Enviro Steamer emits steam, begin using
it, passing slowly over the surfaces to be cleaned.
This is the ideal method for thoroughly cleaning your
floor. To disinfect specific areas of the floor, leave the
steamer over the spot for a minimum of eight seconds,
but no more than 15 seconds.
WARNING: Never turn the floor steamer over, or on its side when using
steamer, or direct steam at any person or animal. Use only on
floors.
8.
When Enviro Steamer no longer emits steam the water refill light will come on (F).
This means that there is no more water (this will happen after approximately 15
minutes of use). Place appliance on preheating/cool down stand, turn off (Fig. 5)
and unplug from the electrical outlet. Take off the cap, and refill. During refilling, be
careful not to touch the hot parts of the device. CAUTION: Cap and floorcloth may
be hot.
9. Replace cap, turn your Enviro Steamer on again and steam will start to be produced
as before.
On/Off
Fig. 5
