User manual
21
• Programs
Select if buttons for selection of chemicals shall be visible or not on the start screen.
There can be a maximum of three buttons for chemical selection. One for detergent, one for bleach and one for softener.
For each button it is possible to select the following:
– Off
– Show all
– Show all + None
Off means that there will not be a button for the selection of that chemical type on the start screen.
Show all means that there will be a button for that chemical type on the start screen.
If show all is selected for detergent, bleach or softener a list with all chemicals of that type that are used in the wash pro-
gram will be shown when the user touches the corresponding button on the start screen.
Show all + None means that it will be possible to select No detergent, No bleach or No softener as well.
• Stop button visible on screen saver
– Select if the stop button should be visible on the screen saver or not.
• IWS overload protection
– Select if the overload protection should be active or not.
• IWS underload protection
– Select if the underload protection should be active or not.
• Timeout for buzzer
– Set for how long the buzzer should be activated in pause and at program end.
• Show time
– Select if the estimated program duration and the remaining time shall be shown. The calculated program duration is
shown before the program is started, the remaining time is counting down and is adjusted during program execution.
• Repeated start
– This function is only used for test purposes.
Inlet water
Estimated temperature: This value is used in the calculations of program duration in heated machines. In case the inlet tem-
perature is much lower or higher an adjustment of this value will give a more precise calculated program duration time.
Drum filling flow rate: This value is used in the calculations of program duration. In case the water pressure is low an adjust-
ment of this value might be needed to get a more precise calculated water filling time.
Fast filling temp limit: If the filling phase temperature is lower than this and higher than 0
℃
/32
℉
both cold and hot water
valves will open simultaneously.
Customers
Here it is possible to make a personal list of customers.
Price programming
In this menu all parameters related to price programming are set.
• Coin value (the value for one coin pulse).
• Prices for each program.
• Prices for options.
• Free program start (makes it possible to start programs without paying.
• One time program start (this program can be used once without paying).
Power balance
The machine has a sophisticated system that ensures the highest possible dewatering even if the load in the drum is uneven
and unbalanced. The system is continuously, during the whole extraction time, adjusting the drum rotation speed to avoid
unbalance and vibration but still maintain the high G-force and dewatering. The same system can be used to decrease the
already low vibration when needed.
Cost calculation
Select the supply voltage in your location (this is needed to get the correct energy calculation). Enter the energy and water
prices in your location to get the correct cost calculation.
If needed, in case the water pressure is lower than what is stated in the installation manual, adjust the valve's flow rates, to
get a more accurate calculation of water consumption.
Detergent box
It might be needed to adjust the flush times due to local conditions (water pressure, type of detergent used etc). The flush
sequence in a compartment with siphon needs to have a flush time long enough to start the emptying and after that a pause
long enough for completely emptying the compartment. It is recommended to repeat the flush to make sure that no residual
chemicals will remain in the compartment.
Weight calibration
If the displayed weight deviates from the actual one, a zero calibration may be required. Follow the instructions on the
screen.
Happy hour
Here you can set discounts (in % or fixed amount) for weekdays and times of days.
