19
3. Lift the unit on one side so that all installation connections
are inside the appliance.
4. Carefully lower the appliance and then move it into the
correct position. Finally, remove the transport palette.
5. Remove the outer protective film and the edge covers,
taking care not to scratch the surface of the appliance.
Very slowly pull off the protective film on the stainless steel
surfaces, without ripping, to prevent any adhesive residue.
Remove any adhesive residue with a non-corrosive
solvent. Then rinse and dry the spot thoroughly.
F.5
Installing on steel plinth or adjustable
feet
NOTE!
If installing on a steel plinth or adjustable feet,
always make sure these are attached to the
appliance beforehand. There are no tools for
taking the unit down from the transport pallet and
putting it in place; all you need is manpower, with
two to four men required depending on the size of
the unit.
1. Transport the appliance on its transport pallet directly in
front of the point of installation.
The installation connections that are sticking out of the
floor should be as close as possible to the side of the
transport pallet.
2. Remove the pre-cut plate at the bottom of the appliance.
(for access, see E
3. Shift the appliance onto the transport pallet such that all of
the installation connections lie within the appliance.
4. Tip the appliance until it is standing on the floor. Then lift at
the front and remove the transport pallet.
5. Carefully lower the appliance and then move it into the
correct position.
6. Remove the outer protective film and the edge covers,
taking care not to scratch the surface of the appliance.
Very slowly pull off the protective film on the stainless steel
surfaces, without ripping, to prevent any adhesive residue.
Remove any adhesive residue with a non-corrosive
solvent. Then rinse and dry the spot thoroughly.
F.6
Disposal of packing
The packing must be disposed of in compliance with the
current regulations in the country where the appliance is used.
All the packing materials are environmentally friendly.
They can be safely kept, recycled, or burned in an appropriate
waste incineration plant. Recyclable plastic parts are marked
as follows:
Polyethylene
• Outer wrapping
• Instructions bag
Polypropylene
• Straps
• Top packaging panels
Polystyrene foam
• Corner protectors
The parts in wood and cardboard can be disposed of,
respecting the current regulations in the country where the
appliance is used.
F.7
Securing or adjusting to the floor
(optional)
If you need to secure it to the floor, the appliance comes with
compatible adjustable feet.
We recommend you adjust the feet so you end up with a
working height of 900 mm / 35,43″. Level the unit with a spirit
level.
A.
Attaching the unit with screws
The feet have metal plates which may be secured to the
floor using screws .
B.
Attaching the unit by welding
The metal plate underneath the feet must be welded to the
floor with a continuous weld around the outer edge.
100 - 200 mm
3,94 - 7,87“
1
