Electrohome WINSTON EANOS501, Manual For Use

Page: 5 / 17

- 8 - - 9 -
1. Phonograph Lid
Lift to reveal turntable
2. Phonograph Lid Support Stand
Lift and clip into place to hold
up lid
3.
Speakers
4. FM Dial Scale
Indicates the FM channels
5.
FM Stereo Indicator
Indicates FM stereo is ON
6. Tuning Control
Indicates which station is
being played
7. Repeat Button
Repeat 1 or all songs on a CD
8.
AM-FM-CD-PH-AUX Function Switch
Changes the player function
9. Program Button
Program a set of songs to play
10. Play/Pause Button
Plays/Pauses playback
11.
Stop Button
Stops playback
12. CD Disc Tray
Holds the CD in the unit
13.
AM Dial Scale
Shows the AM stations
14. CD Track Display
Displays the track currently being played
15. Open/Close Button
Opens and closes the CD tray
16.
Volume Control
Control the volume of playback
17. Random Button
Shuffle and play songs randomly
18. Headphone Jack
Plug your headphones in here
19. Skip Forward Button
Skip to next track
20. Skip Reverse Button
Skip back one track
21. Service Sticker
Allows access to adjustment screw
22.
AUX IN Input
Connect your MP3 player
or smartphone to play to music
23.
ON/OFF Switch
Turns power ON and OFF
24. FM Antenna Wire
Improves FM reception
25.
AC Power Cord
Plug AC power cord into any wall outlet
26. Turntable
Place vinyl record here
27. 45 RPM Adapter
Place in centre of turntable to
accommodate 45 RPM records
28. Transit Screw
Tighten during transportation
29. Cue Lever
Raise or lower tone arm
30. Speed Selector (33/45/78 RPM)
Select speed record should be played at
31.
Tone Arm Lock
Locks stylus arm
32. Tone Arm with Stylus
Plays records
BUTTONS AND CONNECTIONS
Transit Screw UNPACKING AND SETUP
• Carefully remove the unit from the display carton
and remove all packing material from the unit.
• Unwind the AC power cord and extend it to its full
length.
• Unwind the FM Antenna wire and extend it to its
full length.
• Place the unit on a stable, level surface, close to
an AC outlet, out of direct sunlight, and away from
sources of excess heat, dust, moisture, humidity, or
strong magnetic fields.
• Raise the lid to expose the phonograph. The phonograph has been secured for shipment with a transit
screw. Use a coin or screwdriver to TURN THE TRANSIT SCREW CLOCKWISE. This will allow the turntable
to “float” and turn freely.
• Remove the opaque white plastic stylus cover from the
phonograph stylus by sliding it in the direction of the
arrow.
• Discard the stylus cover.
• Remove the twist-tie that was used to secure the tone
arm during shipment.
• Release the tone arm lock lever.
• Connect the plug to your AC outlet, as shown below.
POWER SOURCE
This system is designed to operate on normal 120V
60Hz AC only. Attempting to operate this system
from any other power source may cause damage to
the system, and such damage is not covered by your
warranty.
Note: This system is equipped with a polarized AC power plug having one blade wider than the other.
This is a safety feature. If this plug does not fit into your existing AC outlet, do not try to defeat this safety
feature by altering the wide blade to make it fit into your outlet. If this plug will not fit into your outlet,
you probably have an outdated non-polarized AC outlet. Have the obsolete outlet changed by a qualified
licensed electrician.
PREPARATION FOR USE
Tone Arm
Lock Lever
Stylus Cover