Go-Go Dancer - INSTRUCTIONS
9
M O D E L S
34
Position the assembly from the previous step over the right
Fuselage Side and fit all of the tabs into the notches. DO NOT glue
any of the parts yet. Remember to use the side that will have the
part numbers facing inside.
35
Position the left Fuselage Side against the Former assembly
and fit the Former tabs into the Fuselage Side notches.
36
Hold the Sides in contact with the Formers. Glue (C/A)
Fuselage Formers and Servo Tray (FF3, FF5 & ST) to the Fuselage
Sides (FS). DO NOT glue Fuselage Former (FF4) to the Fuselage Sides
until Step 38.
37
Tack Fuselage Former (FF2) in place between Fuselage
Sides.
38
Slip Fuselage Side Doublers (FSD) into slot between
Fuselage Side and FF2. Rear tip of FSD fits into the slot between
the Fuselage Side and FF3. This doubler forms a lip to help keep the
Hatch in place during flight. Glue FF2, FSD, and the front half of FF4
to the Fuselage Sides.
39
Attach the 1/32" plywood Battery Hook Reinforcement
(BHR) and 1/8" Lite-Ply Battery Hook (BH) to each Fuselage Side
just ahead of FF2.
Note
: The open end of the Battery Hook should be facing down. See
inset picture.
