Go-Go Dancer - INSTRUCTIONS
10
M O D E L S
40
Use C/A to attach Fuselage Former (FF1) to the front end of
the Fuselage Sides.
41
Attach Fuselage Top (FT1) to the top front of the Fuselage
Sides.
42
Build the Motor Mount and Fuselage Former sub-assembly
as pictured. This assembly uses 1/16" plywood Motor Mount pieces
(MM2 & MM4 – MM6), balsa Motor Mount pieces (MM1 & MM3),
plus Lite-Ply Fuselage Former (FF7). Glue MM5 and MM6 together
first, then fit the rest of the pieces together and C/A all the joints to
lock everything in place.
43
Sand the front bottom edge of MM1 flush with the bottom
edge of MM3.
44
Fit the tabs of Fuselage Former (FF6) into the Fuselage
notches.
45
Slide your Motor Mount assembly in place between the
Fuselage Side from the back.
46
Use C/A to lock the Motor Mount/Fuselage Former assem-
bly to the Fuselage Sides. C/A Fuselage Former (FF6) in place.
47
Finish gluing the rear part of Fuselage Former (FF4) to the
Fuselage Sides.
48
Fit Fuselage Formers FF8, FF9 and FF10 between Fusleage
Sides. Make sure the labels on each part face the front of the
airplane and are right-side-up. The small holes in each piece are
the guides for the push rods. Tape the rear of the fuselage sides
together to help hold these Formers in place for the next step.
