Go-Go Dancer - INSTRUCTIONS
12
M O D E L S
Hatch Construction
57
Glue Hatch Sides H4 and H5 together over the Plans. Make
two of these side assemblies.
58
Glue Hatch side H6 to the inside corner of each assembly.
H6 is a reinforcement for the joint between H4 and H5. Make sure
you make a left and right side as pictured here. Make a left and right
side with the laser-engraved part numbers on the inside so they
will not be visible through the covering.
59
Position Hatch Top pieces (H2 & H3) on the tabs of one of
the Hatch Sides. Fit the other Hatch Side in place.
60
C/A Hatch Sides and Top together.
61
Fit and C/A Hatch Top (H1) in place on Hatch sides. Check
Hatch fit on Fuselage.
62
C/A a Magnet into the Hatch (H9) piece and Fuselage For-
mer (FF3). Make sure they are attracted to each other. C/A Hatch (H9)
to the rear side of Hatch.
Important:
The H9 part number should be
right-side-up.
