source match your spotlight specifications.
Check your device as well as your equipment’s grounding.
This device is only meant for indoor use ; protect it from heat and humidity (allowed
ambient temperature from 10 to 40°C).
The spotlight must be set up in a ventilated area, at least 50cm away from any adjacent
surface. Check that no ventilation hole is blocked.
Unplug the spotlight’s power source before any maintenance or handling operation.
Only replace the fuse by a fuse of the same type.
In order to avoid any fire hazard, check for any flammable source nearby.
Use safety cables to secure the spotlight. Hold the spotlight only by its carrying handles to
avoid degradation and risk of injury.
Switch off the power and let the spotlight cool down for about 15 minutes before transport,
for the spotlight’s surface may be hot still.
In the event of a serious functioning problem, stop immediately to use the device. Do no
ever try to repair the device by yourself. Repairs made by unqualified individuals may
cause damages or malfunctions. Contact the nearest approved technical support center.
Always use spare parts of the same type.
Do no connect the spotlight to any dimmer or power pack.
Do no open the device during its operation, the high voltage may cause a lethal electrical
shock.
In order to prevent or reduce risks of electrical shock or fire, do not expose the device to
rain or humidity.
Do not ever touch the led with your bare fingers after use to avoid serious injuries, for the
led may be very hot still.
Do not start the spotlight without led to avoid degradation of the box..
Replace the box and the lenses if they are visually damaged (for example cracks or
deep cuts during transport or handling). This is essential.
Do not look straight at the light going out of led when the spotlight is switched on.
In order to prevent any risks of electrical shock you must not remove the cover. There is
no useful part for the user inside. Refer the repair to qualified personnel
.
Installation
The spotlight must be attached via its screw holes to the support with help of the provided
hook. Always make sure the spotlight is firmly attached to avoid vibrations and sliding during
the operation.. Always make sure the structure to which the spotlight is attached is secured and
able to bear 10 times the projector’s weight.
3
