12
en | Installation and wiring
ZX1i Series Loudspeaker
2022-01 | 04 | F.01U.177.815
Installation Manual
Electro-Voice
2.2.5
Wiring the speaker
!
Caution!
Touching uninsulated terminals or wiring may result in an unpleasant sensation.
To wire the speaker:
1.
Connect the wires to the speaker using the detachable 4-pole Phoenix connector.
2.
Strip back the wire insulation and ensure that no bare wire is exposed beyond the
Phoenix connector.
The four connections allow for convenient loop through wiring to the next speaker system
wired in the system.
2.2.6
Securing the seismic tab connection point
The rear of the enclosure includes an eyebolt for connection to a seismic restraint.
To secure the seismic tab connection point:
1.
Connect the eyebolt in the rear of the enclosure to a properly rated hardware fitting that
is securely installed independently of the QuickSAM™ bracket.
2.
Maintain a 12-inch (305 mm) maximum length of slack or less.
i
Notice!
Even if your local construction code does not require the installation of a secondary support,
its use is highly recommended as additional security.
A
A
B
Figure 2.4:
Wiring and seismic tab connections
A Seismic security cable
B Phoenix connector and wires
2.2.7
Testing system operation
After all connections are made:
