ZX1i Series Loudspeaker
Installation and wiring | en
11
Electro-Voice
Installation Manual
2022-01 | 04 | F.01U.177.815
2.2.4
Attaching the speaker to the QuickSAM™ bracket
C
A
B
Figure 2.3:
Attaching the speaker to the QuickSAM™ bracket
To attach the speaker to the QuickSAM™ bracket:
1.
Insert the QuickSAM™ bracket (C) into the slot on the side of the speaker until it “clicks”
in place.
2.
Using the provided mounting tool, tighten the two socket head bolts (A and B) enough to
allow aiming.
3.
Select the proper horizontal angle and secure the sweep axis by tightening the socket
head bolt A.
4.
Select the proper vertical angle and secure the rotation axis by tightening the socket
head bolt B.
To tighten the recessed socket head bolt B, insert the mounting tool through the hole on
the side of the speaker.
!
Warning!
The socket head bolt B is what secures the speaker to the QuickSAM™ bracket. It is the
installer’s responsibility to ensure that the bolt is fully tightened. Failure to tighten the bolt
may allow the speaker to disengage from the QuickSAM™ bracket, possibly resulting in
serious injury. Use of seismic restraint is highly recommended. Refer to
tab connection point, page 12.
Refer to
–
