Stacking X1 & X2 loudspeakers onto a X12T-DOLLY
!
Caution!
Two (2) person lift and placement is recommended for the heavier loudspeakers. Single
person lift and placement of heavier loudspeakers could cause injury.
!
Caution!
Ensure the correct dolly pins are released from the dolly base. There are four (4) dolly pins
for each stack on the dolly base. There is a total of eight (8) pins on the dolly base.
If the column of enclosures is lifted with the dolly pins still locking to the speakers to the
base, the dolly base will lift and tip. Property damage and personal injuries may occur.
Notice!
Dolly Wheel (the 4º hole):
The bottom element to be landed on the dolly base must be pinned in 4° hole ( ) in the
ANGLE SELECT section. Compress the rear link bars until they contact the angle select pin
and lock by adding a second pin in the EVEN holes of the ANGLE LOCK section.
Ensure the two (2) front link bars are lowered and locked.
To stack X1 or X2 loudspeakers onto a dolly, do the following:
1.
Release the four (4) dolly pins (A) on the dolly.
All four (4) dolly lock pins are released and hanging from the dolly.
2.
Guide the loudspeaker (B) onto the dolly with the grille facing out.
3.
Insert the four (4) dolly pins (C) to lock the loudspeaker onto the dolly.
Ensure the dolly pins are secure.
4.
Pull and twist the four (4) captive twist lock pins (D).
All four (4) captive twist lock pins are in the unlock position.
6.5.1
X-LINE ADVANCE Systems
2015.04 | 02 | F.01U.310.953
Installation Manual
Electro-Voice
